Programming Manual
http://www.remotecontrol-express.com
-
TEL :
+44 (0) 207 399 7782 - FAX :
+44 (0) 207 927 3151
On a KEASY 5/10 –SLD5000/7000 – LS 8900 gate
1.
Open the casing of your receiver. It is located next to your motor.
2.
Press a button on your new remote control. Keep it pressed down. The LED light on your new
remote control blinks.
3.
On the receiver circuit board, press the programming button while keeping the button on
your new remote control pressed down. Let the buttons go. The LED light on your new
remote control remains lit constantly.
4.
Wait 10 seconds.
5.
Your new remote control is programmed.
As a replacement for a SIMINOR 433 NLT2 or 4 remote control
1.
Open the casing of your receiver. It is located next to your motor.
2.
On the receiver circuit board (diagram above), press the programming button PR.
Keep it pressed down. The LED light on the receiver illuminates (LR). Let the button go.
3.
Press the button on your new remote control. Keep it pressed down. The LED light on the
receiver blinks. Let the button go.
4.
Wait 10 seconds.
5.
Your new remote control is programmed.
Remark:
You can perform this last operation with the button PV and the LED light LV.