6. RESTORING AND TRANSPORT THE STAND
1. Reverse the lifting procedure to restore the masts, insert the mast pin (J) in the highest hole to avoid
the movement of the masts. remember to insert the split pin (K).
2. Reverse the position the stand procedure to fold up the legs. Make sure that the spring pin (E) are
restored to lock the leg-brace slider (G) to the legs (A). Tighten all of the leg-brace screw jacks (H) to
make sure all of the legs (A) are in the vertical position.
3. For moving, use handle (P) and the wheels (Q).
7. IMPORTANT SAFETY MEASURES
1. Be respect the factory guidelines concerning the load limits as well as the safety codes of material and
staff. The choice of trussing and the stand capacity must be adapted to the load.
2. Adequate safety measures must be taken when people work under the loads carried by the truss and
the stands, safety steel slings and chains must be used on every item hung on the truss.
3. The indicated loads are without load of snow and load of earthquake.
4. The operator must take into account the weight of the holding truss on the stand and deduct it from its
allowable load.
5. The maximum load applied shall be considered static, vertical and axial. The area of the load should
not exceed 1.0 m on the front.
6. The suspended load must be static and it must be prevented each movement.
7. For other loads than those specified and for surfaces bigger than 1,0 mq on the front, it must be
realized a new technical report by competent and qualified technician.
8. The structure must be placed on a perfectly horizontal plane and with sufficient strength.
9. With winds exceeding 50 km / h (13.89 m / s) the structure becomes unstable and the load must be
lowered to the ground. Therefore it is required the presence of a technician assigned to a constant
control of structure.
12
