PROEL AEQ31, Руководство пользователя

Страница: 8 / 11

•
6.3mm. (1/4”) TRS jack balanced connector – wiring diagram:
•
RCA unbalanced connector – wiring diagram:
Operations
a. To turn on the unit press the POWER switch ON, its led will be lit.
b. To turn off the unit press the POWER switch OFF, its led will be turned
off.
c. To increase or to decrease each band level, raise or lower the
frequency slider (fig.1 ref.1) of the frequency you desire to modify, in
20Hz - 20 kHz range.
d. If CLIP LED is steadily lit the input signal level must be lowered: turn
down the LEVEL (fig.1 ref.2) slider until when the CLIP LED flashes on
musical peaks only.
e. RANGE (fig.1 ref.8) switch allows to choose the cut/boost range (±6dB
or ±12dB) of 31 band sliders.
f. BY-PASS (fig.1 ref.6) switch can be used to defeat equalizer controls,
without the need to turn it off or to put all the slider at zero position.
g. HI-PASS (fig.1 re.3) switch turns on the unit hi-pass filter, that
attenuates by 12dB/oct. all signals below 40 Hz.
h. LOW-PASS (fig.1 ref.4) switch turns on the unit lo-pass filter, that
attenuates by 12dB/oct. all signals over 16 KHz.