14/16
2014/05 - Indice de révision : D - code : 0034401
BEFORE PROGRAMMING THE ENDS OF TRAVEL:
- Check that the key switch is set to “0”.
- Check that the motor pit switch is correctly positioned.
- Energise the control panel (the orange switch lights up).
PROGRAMMING THE ENDS OF TRAVEL:
- Press buttons 2 and 3 simultaneously, hold them down for 3 seconds.
- Release them, and press button 1.
- The red LED on the control panel starts to blink and continues to blink until
programming is complete. If the LED does not blink, switch off the control panel
then switch it back on ans start over.
- Using the key switch, roll the cover out fully over the pool, stop it when the leading
slat touches the wall opposite the axle.
- Press button 2 to confirm the closed position. The LED will continue to blink.
- Roll the cover up fully, stop it when the leading slat is 10cm below the water level.
If the pool features a shaped step (Roman or square), stop the slat apron 10 cm
behind the beam.
- Press and release button 3. The LED goes off. Programming is complete.
Perform 2 “open/close” cycles to check that the cover is being rolled up and out correctly.
The cover should stop by itself at the end of travels in both directions.
POSITIONING MOTOR PIT SWITCH:
Depending on the side of the pool on which the motor is positioned, the switch should be
pushed to one side or the other according to the diagrams below:
Basculer l’inverseur à gauche
Push the switch right
Motor pit
Pool
Pool
Cover pit
Cover pit
Motor pit
PROGRAMMING ENDS OF TRAVEL
Programming buttons
Programming LED
Position of the motor pit
On/off switch
Cleaning manifold switch
