www.usaprocom.com
200285-01C
2
ASSEMBLY AND OPERATION INSTRUCTIONS
DISCONNECTING WALL
MOUNTED HEATER
Wall mounted heater must be disconnected
from gas supply and removed from wall before
installing fan accessory. Contact a qualified
service person to do this. Follow all codes.
REMOVING PANEL FROM BACK
OF HEATER
If your heater has a knock-out panel, remove
panel at the four tabs with a Phillips head
screwdriver (see Figure 1). If your heater
has an installed panel, remove panel with a
screwdriver.
Panel
Fan/Blower
Assembly
On/Off Switch
Auto/O/Man Switch
Figure 2
Figure 1
Figure 3
FAN OPERATION
To operate in Manual mode, turn on/off switch
to the ON position. To operate in Automatic
mode turn AUTO/O/MAN to the desired posi-
tion, Man position will remain constantly on.
Auto position will be controlled by the sensor
on fan blower unit. To stop the operation, turn
unit switch to the O position (see Figure 3).
MAN O
AUT
O
ATTACHING FAN/BLOWER
ASSEMBLY
Attach fan/blower to the rear panel of the
heater using the four screws from step 2
(see Figure 2).
ELECTRICAL CONNECTION
Do not use this fan/blower if
any part of it has been under wa-
ter. Immediately call a qualified
service technician to inspect the
fan/blower and replace any part
of the electrical system which
has been under water.
This fan/blower accessory must be grounded.
This unit comes with a 3-prong grounding plug
for your protection against electrical shock.
Use standard, 3 holes, grounded outlet. If an
extension cord is needed it must have a 3
prong plug and a 3 hole receptacle. An under-
sized cord will cause a drop in live voltage and
could result in loss of power and overheating.
