PROCEED AVP2, Руководство пользователя

Страница: 65 / 100

65
If you are the owner of the AVP2 (rather than a professional installer), this sec-
tion is likely to be of little interest. It’s the one section you should feel free to
skip entirely. In it, we will cover:
• teaching new IR commands from the AVP2 to a learning remote
control
• programming the two DC “trigger” outputs on the Audio Video
Preamplifier
• the use of the rear panel IR input
• the use of the rear panel RS-232 port
• integrating the AVP2 into a PHAST home automation system
• using the AVP2 with other Madrigal “PHAST-Linked” products
In short, you may have to be a bit of a gearhead to enjoy this section. Feel free to
skip it if this sort of thing puts you to sleep.
teach IR commands
to your remote
The AVP2 itself can transmit all of the IR commands to which it can respond
from its
main display
window, enabling you to teach a learning remote both the
standard commands available from the AVP2 remote and a number of other, op-
tional commands which you might find useful.
When using the AVP2 itself to teach new commands to your remote control, your
remote will (obviously) have to be in its learning mode. Therefore, to avoid inad-
vertently learning menu-navigation commands from the AVP2 remote, you must
navigate the on screen menus by using the buttons on the front panel of the
AVP2. The buttons on the front panel you need to use are as follows:
•
recall
: the
menu
function is provided by the
recall
button. In order
to activate the on screen menus rather than simply recalling the
calibrated output level settings,
press and hold
the recall button un-
til the front panel lights are turned off (about ten seconds). From
this point on until you exit the menu system, the recall button will
perform exactly as the menu button on the remote control would.
•
volume knob
: the front panel
volume knob
operates in the same
fashion as
volume
±
buttons on the remote control.
•
mute
: the
enter
function is provided by the
standby
button on the
front panel (when the AVP2 is in menu mode).
1 ENTER THE SETUP MENU
2 SELECT “CUSTOM,” AND THEN “TEACH REMOTE”
3 TO RELEARN THOSE FUNCTIONS WHICH HAVE CORRESPONDING
FRONT PANEL BUTTONS, CHOOSE “PANEL BUTTONS”
The on screen display will prompt you to press any button. Line up the IR
window of the AVP2 remote control with the right side of the main display
of the AVP2, at a distance of approximately 6"-12". Select the to-be-learned
button on the remote, then press the corresponding button on the AVP2.
The display will generate a marquis to let you know that the IR signal has
been transmitted. You may repeat this process until all buttons have been
learned.
To exit,
press and hold
the
recall
button (which serves as a
menu
button
when you use front panel controls within the menu system—merely press-
ing it in this case will result in the recall command being transmitted).