Manufactured by ProBuilt Professional Lighting: 877-707-0800
Thank you for purchasing Wobblelight
®
IMPORTANT SAFETY INSTRUCTIONS
WARNING !!!
READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.
SAVE THESE INSTRUCTIONS
This manual contains important safety and operating instructions for Wobblelight
®
portable job site lighting. Before using Wobblelight
®
, please review all of the
following safety instructions carefully and read all labels on the Wobblelight
®
unit.
INSTRUCTIONS PERTAINING TO THE RISK OF FIRE, ELECTRIC SHOCK, EXPOSURE TO UV RADIATION AND INJURY TO PERSONS:
WARNING
: To reduce the risk of fire, electric shock, exposure to excessive UV radiation or injury to persons:
x
DO NOT connect Wobblelight
®
to power source until the bulb is installed and the unit is completely assembled.
x
Metal halide and halogen bulbs get EXTREMELY HOT immediately upon illumination and can cause burns.
x
Bulbs stay hot for an extended period of time after Wobblelight
®
unit has been turned off, and can continue to cause burns.
x
DO NOT attempt to remove the protective lens to change bulbs unless the Wobblelight
®
unit is disconnected from the power source and the bulb has
completely cooled.
x
Not for use in wet locations. DO NOT use Wobblelight
®
where this is potential for exposure to excessive moisture from rain, snow, ice or water spray or
standing water.
x
DO NOT leave Wobblelight
®
units operating for extended periods of time in unattended areas.
x
Connect
Wobblelight
®
only to 120 volt, 60 Hz power source which is protected with a ground-fault circuit interrupter (GFCI) and over-current protection.
Any other connection voids warranty.
x
Wobblelight
®
is not recommended for use with generators except under emergency situations or when the generator output power is carefully monitored to
stay /-10% of 120V.
x
Keep away from flammable materials.
x
Wobblelight
®
must be operated in the upright position only. DO NOT mount Wobblelight
®
units upside down or restrain them such that they lay on their
side.
x
Use only approved extension cords in good condition and of the appropriate type, gauge and length for each application.
