9
PROBRITE.COM
Please call 1-844-507-5651 or email [email protected] for further assistance.
8
Visit
www.probrite.com/install
for installation video tutorials and product support
C
D
DD
A
B
Installation (continued)
Operation (continued)
7
Mounting the light
fixture
☐
Once the fixture is wired, place the
light fixture (A) onto the mounting
plate (D) so the top sloped grove on
the plate rests on the top sloped grove
on the back of the fixture.
☐
Verify the fixture is flush with the wall
and photocell (B) is pointed upward
for wall mount.
☐
Tighten the mounting plate tightening
bolt (C) back through the hole on the
bottom of the fixture (A) until the bolt
firmly pushes against the mounting
plate (D).
8
Caulking around the
light fixture
☐
Caulk around the mounting plate (D)
and surface with silicone sealant (not
included).
D
NOTICE:
Failure to properly caulk around the
surface and mounting plate (D) could lead
to water damage and is not covered under
warranty.
NOTE:
When attaching this fixture (A) to an
external, surface mount junction box, caulk the
inside of the light fixture before attaching to the
mounting plate (D).
☐
To enable dusk-to-dawn operation
remove black cap cover and ensure the
photocell (B) has clear cap cover (CC)
on it and is unobstructed.
☐
Ensure the switch powering the outlet
connected to the light fixture is turned
to the ON position and
leave it ON
at all times to enable dusk-to-dawn
functionality to operate automatically.
NOTE:
If photocell (B) is located in an area
under heavy shade the photocell may not
detect enough light and may turn the light
fixture on.
TIP:
To test if the light fixture (A) and
photocell (B) works properly run power to
the fixture and cover the photocell to turn
fixture ON. Shine a light into the photocell to
see if fixture turns OFF.
OPTION 2: SWITCH CONTROLLED
Switch controlled operation enables the light fixture to turn ON and
OFF by flipping a switch that controls the electricity to the outlet
powering the fixture. The light fixture will not turn ON and OFF
automatically, but is manually controlled.
(Leave the black cap cover over the
photocell)
☐
To enable switch activated operation
leave the black screw-on cap the
photocell (already installed on the
fixture) and remove the instructions
label.
A
CC
F
(Remove Opaque Cap Cover (CC)and
replace with Clear Cap Cover (F) on
photocell for Dusk-to-Dawn Operation)
Operation
1
Selecting Dusk-to-Dawn or
Switch-Activated control
OPTION 1: DUSK-TO-DAWN OPERATION
Dusk-to-dawn operation enables the light fixture to automatically turn
ON when dark outside and turn OFF when the sun rises, thus saving you
energy.
A
B
Care and Cleaning
☐
Shut off main power supply before cleaning the product. To prolong the original ap-
pearance, clean the light fixture with clear water and a soft, damp cloth only.
☐
Do not use abrasive cleaners or cleaners that contain alcohol. Do not apply paints,
solvents, or any other chemicals on this light fixture. They could cause a premature
deterioration of the finish and may void the warranty.
☐
Do not spray the light fixture with a hose or power washer.
AUTOMATIC
NIGHTTIME ON
DAYTIME OFF
Swap
SWITCH
CONTROLLED
