background image

Zelos

 Twin  36

Binding

The included transmitter and receiver are bound at the 

factory. To rebind:

1. 

Power off the transmitter and ESC.

2. 

Insert the bind plug into the BIND port on the receiver.

3. 

Connect a fully charged battery to the ESC, then power 

on the ESC. The LED in the receiver flashes continuously, 

indicating that the receiver is in bind mode.

4. 

With the throttle in neutral, power on the transmitter by 

pressing the bind button. The LED in the receiver turns 

solid and the ESC will beep and arm when binding is 

complete. The ESC is ready for use.

5. 

Always remove the bind plug from the receiver after 

binding is complete.

You must rebind when binding the receiver to a different 

transmitter.

NOTICE: 

Do not attempt to bind the transmitter and 

receiver if there are other compatible transmitters in bind 

mode within 400 feet. Doing so may result in unexpected 

binding.

Failsafe

In the unlikely event that the radio connection is lost during 

use, the receiver will drive the servo and ESC to their pre-

programmed failsafe positions (normally no throttle and 

straight steering).

 

If the receiver is powered on before powering on the 

transmitter, the receiver will enter this failsafe mode. When 

the transmitter is powered on, normal control is resumed.

Low Voltage Cutoff (LVC)

Discharging a Li-Po battery below 3V per cell may damage 

the battery.The included ESC protects the boat battery from 

over-discharge using Low Voltage Cutoff (LVC). Before the 

battery charge decreases too much, LVC removes power 

supplied to the motor. 
Power to the motors will be reduced significantly, showing 

that the batteries have reached the minimum LVC 

threshold. The ESC is programmed to allow enough battery 

power to drive back to shore from a maximum of 100 yards 

(45m), at no more than 1/4 throttle.

Disconnect and remove the Li-Po battery from the boat after 

use to prevent trickle discharge. Charge your Li-Po battery 

to about half capacity before storage. During storage, make 

sure the battery charge does not fall below 3V per cell. LVC 

does not prevent the battery from over-discharge during 

storage.

NOTICE: 

Repeated operation to LVC will damage the 

battery.

Tip: 

Monitor your boat battery's voltage before and after 

boating by using a Li-Po Cell Voltage Checker (DYN4071, 

sold separately).

Electronic Speed Control (ESC) Programming

STEP 1: Enter Program Mode

1. 

Power on the transmitter and set the throttle to full.

2. 

Connect the battery pack to the ESC. After 2 

seconds, the ESC will beep twice. 

3. 

Wait 5 seconds and the ESC will emit a musical tone. 

STEP 2: Select Programmable Item

The ESC will emit four groups of beeps in a loop.
Move the throttle to neutral within 3 seconds of the tone 

matching the item you want to select.

Beep

Running Mode

Beep Beep

LiPo Cells

Beep Beep Beep

LVC Threshold

Beep Beep Beep Beep

Timing

STEP 3: Set Item Value

After selecting a programmable item, you will hear 

several tones in a loop. 

1. 

Move the throttle to full to select the value matching 

the tone. The ESC will emit an alternating tone to 

indicate selection. 

2. 

Keep the throttle in full to return to Step 2 and 

continue item selection. Move the throttle to the 

neutral within 2 seconds to exit the Program Mode.

STEP 4: Exit Program Mode

1. 

In Step 3, after hearing the alternating tone, move the 

throttle to neutral within 2 seconds.

–or–

2. 

Disconnect the battery pack from the ESC.

9

EN

Throttle Range Calibration

1. 

Power on the transmitter and set the throttle TRIM dial 

to the center position.

2. 

Install the batteries in the boat and connect the batteries 

to the ESCs.

3. 

With the ESCs powered off, pull the throttle trigger to 

full throttle and press the power buttons on both ESCs 

simultaneously. The ESCs will beep twice. The green 

light will flash with each beep.

4. 

Return the throttle to neutral. The ESCs will beep once 

and the green light will flash once.

The calibration process is now complete. The ESCs will arm 

with beeps and flashes to announce the number of battery 

cells it has detected. Reverse calibration is unnecessary.

General Information

Содержание Zelos Twin PRB08021
















Отзывы: