Instruction Manual
Decoy will not connect
(after binding) to
transmitter
Transmitter is too near decoy during
connecting process
Move powered transmitter a few feet from decoy,
disconnect and reconnect battery to decoy
Decoy or transmitter is too close to
large metal object, wireless source
or another transmitter
Move decoy and transmitter to another location
and attempt connecting again
Decoy battery/transmitter battery
charge is too low
Replace/recharge batteries
ESC switch is off
Power on ESC switch
Decoy tends to dive in
the water or takes on
water
The decoy hull is not completely closed
Dry out the decoy and ensure the hatch is fully
closed on the hull before returning the decoy
to the water
Center of gravity is incorrect
Move the battery in the hull
Decoy tends to turn one
direction
Rudder or rudder trim is not centered
Repair rudder or adjust rudder and rudder trim
for straight running when control is at neutral
Rudder does not move
Rudder, linkage or servo damage
Replace or repair damaged parts and adjust con-
trols
Wire is damaged or connections are
loose
Do a check of wires and connections, connect
or replace as needed
Transmitter is not bound correctly
Re-bind receiver to the transmitter
BEC (Battery Elimination Circuit) of the
ESC is damaged
Replace ESC
ESC switch is off
Power on ESC switch
Controls reversed
Transmitter settings are reversed
Do the Control Direction Test and adjust controls
on transmitter appropriately
Motor overheats
Blocked water cooler tubes
Clean or replace water tubes
Motor power pulses
then motor loses power
ESC uses default soft Low Voltage Cut-
off (LVC)
Recharge decoy battery or replace battery that is
no longer performing
Weather conditions might be too cold
Postpone until weather is warmer
Battery is old, worn out or damaged
Replace battery
Battery C rating might be too small
Use recommended battery
11
EN
