Section 3: Installing the Rudder
Step 2. Carefully insert the rudder as shown.
4
Section 2: Attaching the Turn Fin
Step 1. Once the boat stand is complete, place the
Miss Budweiser carefully on the completed boat stand.
Step 2. Locate the turn fin and the included 3mm hex
screws (4) to secure the turn fin.
Step 5. Carefully attach the turn fin onto the right sponson
as shown and tighten the hex screws with a 3mm hex driver.
Step 3. Note the two holes where you will attach the turn fin
have been already drilled for you at the factory. Take a small
diameter hand drill bit to clean out any paint residue that may
be resting inside the holes. Be careful not to enlarge the
holes or the hex screws will not properly fit inside the holes,
preventing you from securing the turn fin.
Parts Needed
Turn Fin
3mm hex screws (2)
Tools and Adhesives Needed
3mm hex driver
Hand drill bit (if necessary)
Blue Threadlock
Parts Needed
Rudder
2.5mm hex screw
Tools and Adhesives Needed
2.5mm hex driver
Locate the included turn fin. This will be attached to the right sponson as it will allow only right turns to be made. Any attempt to turn
the boat left will cause the boat to flip, especially if this is done in a tight diameter and at high speeds.
Step 4. Carefully place a few drops of blue Threadlock on the
threads of all four hex screws. This will help to keep the
screws secured to the blind nuts within the sponson.
Step 1. Locate the stainless steel rudder and 2.5mm
hex screw.
Step 3. Find the flat spot on the rudder. Using the 2.5mm
hex screw, tighten the hex screw on the flat spot as shown.
