3
Installation
3.1
Set Up
1. Place the CPAP device on the heater platform. Position the
CPAP device so that the four feet match up with the four
recessed areas in the platform and the rubber tab at the
back of the platform slips into the slot in the rear of the
CPAP unit (beneath the power socket) locking the device
securely into place.
2. Place the CPAP and heated humidifier base on a flat surface
and at a lower level than your sleeping position.
3.
Connect the power jumper cord to the power socket
(outlet) on the back of the heater and the AC inlet on the
back of the CPAP device.
4. Connect the AC power cord to the power socket (inlet) on
the back of the heated humidifier base, and plug it into
main outlet.
NOTE:
The plug is also serves as a disconnect device.
5
4
Operation
4.1
Operating instruction
Daily Use
1.
Power on the heater by pressing the On/Off switch on the rear
of the heated humidifier base. The power on indicator will be lit
(green light)
2.
Fill the chamber to the fill line with distilled water
(approx. 450 ml).
3.
Press down and slide the chamber into place. Make sure the
silicon connector on the inlet connector fit securely over the
CPAP device air outlet.
Note:
Make sure the water chamber is pushed to the end to
press against the heater plate switch. At the same time,
the heater on indicator will be lit to indicate the heater
plate starts to warm.
Note:
The heater will be automatically turned off while the
water chamber is removed from the heater platform.
4.
Connect the 6’ flexible tubing to the outlet connector on the
water chamber.
Silicon
Connector
Heater Plate
Switch
6
