PROAIM SPIN PAN TILT HEAD 7
Attach the cables of the motors with
the long cable.
BALANCING
Find the horizontal balance point of your camera by using 2 fingers of one hand while hold-
ing the handle.
Mark this point on the side of the camera with chalk or tape.
Turn the unit on and move the tilt control until the camera plate is vertical.
Loosen the two screws holding tilt motor.
(DO NOT REMOVE).
Grasp the motor and turn slightly to disengage gears.
Mount the camera to the camera plate with the screw provided.
Tighten by threading the nut up to the bottom of the camera plate securely.
Make sure your balance point previously marked with chalk or tape is in the middle of the
plate.
Loosen the knob below the camera plate and slide the camera and plate up or down until
the center line of your camera is about in the middle of the large gear. Now tighten knob.
If the camera is perfectly balanced it will stay in any position while motor gear is still un-
attached.
Grasp the motor and turn it back until the gears mesh.
Gently tighten motor screws.
Secure the camera.
