Proaim Drive One Wireless Follow focus (FF-WRLS-DR-ONE)
7
The motor is designed to mount directly onto 15mm support rods, or 19mm rods via the optional 19mm
adapter.
If you have a manual follow focus on the rails, it is recommended that you remove this before mounting the
Proaim motor.
First install the correct drive gear on the motor unit for your lens. These will be 0.8mod for cine lenses,
0.6mod for Fujinon lenses and 0.5mod for Canon lenses. Unscrew the red hub nut, and seat the gear down
on the hub, aligning the two holes with the pins on the hub. Secure by replacing the hub nut.
Slide the motor onto the rod, orientating the tightening knob so it is accessible. Align the gear with the teeth
on the lens ring, but do not engage the gears yet. Tighten the clamp knob to hold the motor in position.
Connect the motor to the receiver using the supplied Lemo cable. Care should be taken to align the red dots
on the connector with the corresponding dot on the socket. The angled end of the cable is for the receiver
and will not plug into the motor.
Route the cable so it is secure and will not upset normal operation or balance of the camera. Ensure that no
cables or loose parts can be pulled between the drive gear and the lens.
Do not turn the system on with the drive gear engaged to the lens.
