Specifications
The display range of temperature ... 41˚F to 95˚F (5˚C to 35˚C)
The control range of temperature.... 44˚F to 90˚F (7˚C to 32˚C)
Load Rating............................................... 1 amp per terminal, 1.5 amp
maximum all terminals combined
Swing (cycle rate or differential) ...... Heating is adjustable from 0.2˚ to 2.0˚
Cooling is adjustable from 0.2˚ to 2.0˚
Power source ...........................................18 to 30 VAC, NEC Class II, 50/60 Hz
for hardwire
Battery power from 2 AA Alkaline
batteries
Operating ambient ............................... 32˚F to +105˚F (0˚C to +41˚C)
Operating humidity .............................. 90% non-condensing maximum
Dimensions of thermostat ................. 4.7” W x 4.3” H x 0.9” D
If the filter change reminder is enabled, you will see a reminder
in
the display when your air filter needs changed.
The reminder will
be shown in the display after your system has run long enough to
require an air filter change.
Resetting The Filter Change Reminder:
When the reminder is
displayed, you should change your air filter and reset the reminder by
holding down the 3rd button from the left side of the thermostat for
3 seconds.
This thermostat also has other maintenance reminders (Humidity
Pad, UV lamp, and IAQ Cell), that are reset with the same procedure.
Filter Change & Other Reminders
45
46
Temporary Hold:
The thermostat will display
HOLD
and
RUN SCHED
on the bottom of the screen when you press the or
key. If you do nothing, the temperature will remain at this setpoint
temporarily for 4 hours. The program setpoint will then replace the
temporary setpoint.
Permanent Hold:
With a temporary hold set, If you press the
HOLD
key at the bottom of your screen, you will see
HOLD
appear below
the setpoint temperature in the display. The thermostat will now
permanently stay at this setpoint and can be adjusted using the
or keys.
To Return To Program:
Press the
RUN SCHED
key at the bottom of
the screen to exit temporary and permanent holds.
Temporary & Permanent Hold Feature
Specifications
47
Remote Sensor Operation
Option #1 - Indoor / Local Temperature Sensor “ON”:
1.
The displayed room temperature will display the average
temperature of the thermostat and all remote sensors.
2.
By pressing the far left (Prev Step) button, the average temperature
of just the remote sensor(s) will be displayed briefly in the clock field.
Option #1 - Indoor / Local Temperature Sensor OFF”:
1.
The displayed room temperature will only show the average
temperature of the remote sensor(s).
Option #2 - Outdoor:
1.
The outdoor temperature will alternate briefly with the clock
display.
Option #3 (Floor)
1.
By pressing the far left (Prev. Step) button, the temperature of the
floor sensor will be displayed briefly in the clock field.
Remote Sensor Operation Options
Features
