6
Wear safety gloves
Wear goggles
Wear ear-muffs
1. Layout
1
1. Miter stop
1
2. Parallel stop
1
3. Wheel guard
1
4. Table
1
5. Water trough
1
6. Housing
1
7. Thumb screw for setting the angle
1
8. Scale for miter cuts
1
9. Thumb screw for wheel guard
10. Thumb screw for parallel stop
12. ON/OFF switch
13. Switch housing
14. Power cable
15. Diamond cutting wheel
16. Outer flange
17. Side cover
18. Nut
19. Splitter
2. Technical data
Motor rating:
600 W S2 10 min
Motor speed:
2950 rpm
AC motor:
230 V ~ 50 Hz
Insulation class:
Class B
Protection type:
IP 20
Length of cut:
unlimited
Length of jolly:
unlimited
Cutting height 90°:
35 mm
Cutting height 45°:
20 mm
Table size
330 x 360 mm
Diamond cutting wheel
ø 180 x ø 25.4 mm
Noise emission values
The noise produced by this tile cutting machine
is measured in accordance with DIN EN ISO
3744; DIN EN ISO 11201: 1996-07 ISO 7960
Annex A; 2/95.
The level of noise at the workplace may exceed
85 dB(A). In this case it is essential to take
suitable precautions to protect the user’s hearing
(wear ear muffs!).
Idle
Sound pressure level LPA
64.4 dB(A)
Sound power level LWA
77.4 dB(A)
3. Important notes
Please read this operating manual carefully and
follow the instructions. Use the manual to familiarize
yourself with the machine, its proper use and safety
instructions.
Important!
For safety reasons it is prohibited for children, young
people under the age of 16 years and all persons
who have not read and understood the operating
instructions to use the tile cutting machine.
Portable tile cutting machine for medium tiles
Cutting performed by a diamond cutting wheel.
Jolly cuts with tilting work top up to 45 degrees.
Cutting wheel cooled with water.
Straight fence and mitre fence.
Removable trough as cooling water container.
(To remove, the machine must be lifted slightly.)
4. Intended use
The tile cutting machine is designed to perform
cutting jobs on small and medium tiles (floor and wall
tiles made of ceramic and similar material) which suit
the machine’s size. It is intended in particular for use
by DIY enthusiasts and craftsmen. The cutting of
wood and metal is prohibited.
The machine is to be
used solely for its intended purpose.
Any use
other than its intended use is a case of mis-use. The
user/operator and not the manufacturer shall be
liable for any damage or injury resulting from cases
of mis-use. Only those cutting wheels suitable for the
machine are to be used. The use of saw blades is
prohibited. For the machine to be used as intended it
is also imperative to observe the safety instructions,
the assembly instructions and the operating
instructions set out in this manual. All persons
entrusted with operating and servicing the machine
must be acquainted with the manual and must be
informed about the machine’s potential hazards. It is
also imperative to pay exact attention to the accident
GB
Anleitung PFSG 180-1 SPK1 16.05.2006 8:18 Uhr Seite 6
