After completing the assembly of the radiator, proceeding to the assembly of the base which
presents a whole series of holes, which have to be equipped and prepared following the pictures
sequence.
Install the 8 bolts 4x25MA in the holes in X shape and 4x16 bolt in the side hole as pictures.
Correct assembling sequence for all the bolts: bolt, serrated washer, normal nut, two flat washers
and self-locking nut.
Block all tightening bolts thoroughly normal nut.
Continue the assembly with the two insulators in which is placed the wider pipe section 35mm.
Leave loose bolts so you can easily move the tube into its final position with the lower side
protruding approximately 2cm from the insulator. Install on the radial 4x20MA bolt and lock, insert
a flat washer, eyelet RF wire, another flat washer and normal nut. Lock bolts of isolators and
assembling the RF choke coil (choke). Making sure that the chock is vertical for a better drainage of
the rain. The choke will short to ground any electrostatic discharge and will reduce noise.
The care and precision of this assembly will ensure a long life to the antenna.
Check that all bolts have been properly secured and completed the radiator assembly.
