pro.point 8913204, Руководство пользователя, Страница: 10 / 100

8913204 Gas Pressure Washer V1.0
10 For technical questions call 1-800-665-8685
4. Remove the red shipping plug from the pump
(#22) and replace with the included pump
dipstick (Fig. 4).
5. Connect the pressure hose (#26) to the outlet
fitting on the pump (#22) by pulling back the
quick connect collar and pushing the Hose into
the fitting (Fig. 5-2). Connect the water supply
hose to the water inlet connection on the
Pump and hand-tighten the Inlet Fitting
(Fig. 5-1). The water source must be able to
provide a minimum of five gallons of clean,
cold water per minute at 40 PSI. Only use a
5/8 in. inner diameter (or larger) hose that
is rated to meet this capacity.
6. Connect the pressure hose to the handle of the
spray gun (#25) by pulling back the quick
connect collar on the Hose and pushing the
Hose onto the handle fitting. Squeeze the
trigger for one minute to purge air from the
system (Fig. 6).
7. Remove the protective cap on the wand (#24)
inlet. Insert the Wand into the spray gun tip and
firmly hand-tighten the nut.
8. Attach the desired nozzle to the wand by
pulling back the quick connect collar and
pushing the nozzle onto the end of the Wand.
Make sure the quick connect collar locks the
nozzle in place (Fig. 7).
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7