HEAVY DUTY STRAIGHT LINE AIR SANDER
8
For technical questions call 1-800-665-8685
V 3.04
8349821
OPERATION
WARNING! To prevent possible
injury and damage to your new tool,
only use paper sanding discs and
follow adhesive manufacturer’s
directions explicitly.
NOTICE! Air tool consumption
ratings CFM, are based upon a
25% duty cycle. If you require
continuous duty, a larger compressor
will be required.
If you are using this tool for the first
time, follow these steps carefully:
INSTALL AIR CONNECTOR
Prepare a standard 1/4 in. NPT male
air connector for use with your tool.
1. Wrap the external threads of the male connector with
sealant tape.
a.
Wrap tape in a clockwise direction so it will not unravel.
b.
Do not tape all the threads. Leave several leading
threads unwrapped for easier alignment.
2. Screw the connector into the tool’s air inlet and tighten with
a wrench until snug.
3. Run compressor at a low volume and check the connection
for air leaks. Do not use the tool until all air leaks are repaired
or the faulty component is replaced.
