10.8V Li-ion Cordless Mini Drill Driver
9
For technical questions call: 1-800-665-8685
V 2.0
8380271
TOOL OPERATION
ATTACHING THE BITS
(Bits Excluded)
INSERT IMAGE 8380271_attaching bit.jpg
1. Insert the bit into the hole of the driver shaft.
2. To remove the bit, pull it out from the bit holder.
TOOL OPERATING
1. How to insert and remove bit:
• To remove a bit from the chuck, hold
“ part B” firmly in one hand and turn
part “A” counterclockwise.
• To insert a bit into the chuck, hold “part B”
firmly in one hand and turn the
“part A” clockwise.
2. Forward / Reverse Rod selection button:
Select the forward or reverse direction of the tool
by pushing the Forward/Reverse Rod.
3. Select the applied torque:
Use the 11 sections adjustment ring to select the
right torque for your application.
4. Drill model:
Select the torque ring to the sign for the
maximum torque position if you would like to drill
into wood.
ELECTRICAL TOOLS
1. The brushes should be checked periodically and worn-out brushes should be replaced. After replacing, inspect
whether the new brushes can move freely in the brush holder. Run the motor for 15 minutes without load to
shape the brushes, so that they are properly aligned with the commutator.
2. Keep the vent passage clear from dirt. Clean off the accumulated dust and oil dirt periodically.
3. During normal operation, if anything happens, the power supply should be cut off at once and the tool should
be checked and repaired.
4. Clean the tool after each use.
CAUTION! Only qualified service personnel should repair the tool.
9.5mm(3/8”) to 11.5mm(7/16”)
6.35mm(1/4”)
Fig. 9
forward
reverse
Forward/Reverse
Rod
Remove the bit
Turn clockwise
