Pro-Max GR14SPTK-CE, Инструкция по установке и эксплуатации

Страница: 4 / 12

4
OPERATING INSTRUCTIONS
1. Turn the unit on by placing the switch in the ON position. The HEAT ON indicator, program number
and display will flash indicating the unit is heating. When the preset temperature is reached, the
heating light, display and program light indicator will stop flashing followed by 3 beeps. (Initial startup
heating time is approximately 30 minutes).
2. Place product on the bottom cooking surface of the unit and close the lids.
3. Press the PROGRAM button and let the displayed time count down to "0" at which time the unit will
beep. To turn off the beeper, press the PROGRAM button again.
4. Raise the lid until it engages into the first detent and remove food. Using a spatula, scrape residue
into the grease catcher tray.
NOTE: Metal utensils may be used, however, using nonmetal utensils will prolong the life of the
cooking surface.
5. Turn the unit off when it is not in use.
TEMPERATURE/TIMER CONTROLLER OPERATION SPECIFICATIONS
Startup:
1. The preset time will flash until the preset temperature is reached.
2. When the control reaches the preset temperature, time display, the HEAT ON indicator and program
indicator will stop flashing and the alarm will beep three times.
Temperature:
1. To view the actual temperature, press and hold the TEMP button. The display will read "Lo" if the
temperature is below 135°C (273°F) and "Hi" if the temperature is above 300°C (573°F).
To Program Time and Temperature:
1. Press and hold TEMP (actual temperature displays).
2. While holding TEMP, press and hold any program button on the left for one second. The LED above
the program number will light and the display will read "_ _ _ _." Enter the four-digit security code
sequence: 4, 3, 2, 1. The security code will not show on the display. Once the correct sequence has
been entered, the preset time will be displayed and the LED for that program will begin to flash.
3. Set the time with the "+ or -" buttons.
4. Press the TEMP button to save the time.
5. The preset temperature will now be displayed.
6. Set the desired temperature for this program using the "+ or -" buttons.
7.
Press the TEMP button to save the temperature and to exit the programming mode for this
program.
The LED will stop flashing but will remain lit.
8. Press any other program button within 15 seconds to continue programming without
re-entering the security code.
9. While programming a program (LED is flashing), if no input is received for 15 seconds the unit will
revert to normal operation and the security code must be re-entered.
NOTE: Temperature settings are done with the Left side buttons only. The time settings
programmed on the left buttons will also be programmed onto the Right side. See the next
section to make time changes to the Right side only. Each programming change must be
saved by pressing the TEMP button!
Right Side (Timer only):
1. To change the time on right, press and hold the TEMP button, then press and hold any program
button on the right for one second. The LED above the program button will light and the right
display will read "_ _ _ _." Enter the four-digit security code sequence: 4, 3, 2, 1. The security
code will not show on display. Once the correct sequence has been entered, the preset time will
be displayed and the LED for that program will begin to flash.
2. Set the time with the "+ or -" buttons.
3.
Press the TEMP button to save the time.
4. The LED will stop flashing but will remain lit.
2M-Z9194 GR14SPTK
SPLIT
-LID T
ABLE T
OP
TWO
SIDED T
OASTER