Pro-Max CG14SPT, Инструкция по установке и эксплуатации

Страница: 6 / 16

6
To Program Time and Temperature:
1. Press and hold "TEMP" (actual temperature displays).
2. While holding "TEMP," press and hold any program button on the Left one second, the
LED above the program number light and the display reads "_ _ _ _." Enter the four-digit
security code sequence,
4, 3, 2, 1 . The security code will not show on the display. Once
the correct sequence has been entered, the preset time will be displayed and the LED for
that program will begin to fl ash.
3. Set the time with the "+ or -" buttons.
4. Press the "TEMP" button to save the time.
5. The preset temperature will now be displayed.
6. Set the desired temperature for this program using the "+ or -" buttons.
7. Press the "TEMP" button to save temperature and to exit programming mode for
this program. The LED will stop fl ashing but will remain lit.
8. Press any other program button within 15 seconds to continue programming without
re-entering the security code.
9. While programming a program (LED is fl ashing), if no input is received for 15 seconds,
the unit will revert to normal operation and the security code must be re-entered.
Note: Temperature settings are done with the left side buttons only. The time settings
programmed on the Left buttons will also be programmed onto the right side. See below to
make time changes to the right side only. Each programming change must be saved by
pressing the "TEMP" button!
Right Side (Timer only):
1. To Change the time on the right side, press and hold the "TEMP" button, and press and hold
any program button on the right for one second. The LED above the program button will
light and the Right Display will read "_ _ _ _." Enter the four-digit security code sequence,
4, 3, 2, 1. The security code will not show on the display. Once the correct sequence has
been entered, the preset time will be displayed and the LED for that program will begin to
fl ash.
2. Set the time with the "+ or -" buttons.
3. Press the "TEMP" button to save the time.
4. The LED will stop fl ashing but will remain lit.
5. Press any other program button within 15 seconds to continue programming without re-
entering the security code.
6. While programming a program (LED is fl ashing), if no input is received for 15 seconds,
the unit will revert to normal operation and the security code must be re-entered.
Operation:
1. Pressing any program button (1-4) will start the timer countdown and display the
preset time remaining. The LED for the appropriate program will be lit during
countdown and remain lit until another program is selected.
2. When the display reaches "00:00", the buzzer will sound and the digits will fl ash.
3. Press the program button to silence the buzzer and return the readout to programmed
time.
4. The right and left sides will operate independently of each other. Both timers can
be in operation at the same time. The "00:00" display will show which side is timed
out.