SIGN CONFIGURATION – MASTER/SLAVE
Follow the instructions in this section to operate two ML+ units as a MASTER/SLAVE
configuration.
NOTE
: Any ML+ unit can be configured as MASTER or SLAVE. It is important to
note that the MASTER will always be the primary signal carrier.
1) Configure one ML+ as a MASTER ONLY configuration. Refer to previous section.
2) Now connect the remaining Data Cable as shown below.
NOTE
: For ease of installation into a cabinet, Data Cable #2 should be made once
partially installed into its final position in the cabinet.
4) Secure all connections by tightening the fasteners or screws.
5) MASTER/SLAVE Configuration complete!
NOTE
: Remaining ports on the SLAVE ML+ unit are not used in a MASTER/SLAVE
configuration.
MASTER ML+
SLAVE ML+
Page 3
Data Cable #1
Data Cable #2
