4
C
. Operating the Work Light
1. Plug the Compressor into a suitable 12V DC power
source.
2. Toggle Light switch to LIGHT position for steady, high-
intensity, work light. Toggle switch to FLASH position
for emergency flashing light. Centered switch position
extinguishes light.
E. REPLACING THE FUSE
(15A 5.2mm dia. x 20mm glass tube current fuse)
1. Unscrew the plastic 12V DC plug cap.
2. Gently remove 15A fuse and replace with fuse of same
rating and size.
3. Place fuse properly in position to allow installation of
plastic cap.
4. Reinstall plastic 12V DC plug cap.
TIPS FOR OPERATION
1. Ensure vehicle battery is sufficiently charged to operate
compressor.
2. If Compressor does not operate when plugged into a
DC 12V outlet, check connections at back of DC 12V
plug as well the receptacle fuse. Replace as needed
with a fuse of identical rating. Never replace with fuse
of higher rating. No user replaceable parts exist for this
item, refer any repairs to qualified personnel only.
3. Do not overheat the Compressor, monitor cycle times
(Compressor on and off periods). Never exceed 15 min-
utes continuous running. Let unit cool for 30 minutes,
then reattempt use.
4. Operate and store in a clean, dry environment. Do not
obstruct the unit’s cooling vents.
Performance Tip:
Keep your tires inflated per the vehicle’s
owner’s manual. This will increase gas mileage and re-
duce tire wear.
SPECIFICATIONS
Model:
W-1704
Power Requirement: 12V DC
Maximum PSI:
100 psi
Duty Cycle:
15 min. on/30 min. off
Power:
105W @ 12V DC
Maximum Air Flow:
0.7 CFM (high pressure)
1.4 CFM (low pressure)
