© Pro-Ject Audio Systems · VC-S2 ALU (from S/N:19F011632) · Revision 2019.10.19
6
1.
Disconnect the mains cable
2.
Remove ventilation outlet grille (4)
3.
Place the drain insert spout into the hole (drain insert is included in the accessories) and
make sure it sits there tightly, so no fluid can reach the inside of the device.
4.
Lift the opposite side of the VC-S2 ALU up to drain the unit reservoir to a big container.
5.
Remove the spout and attach the ventilation outlet grille back to its place.
Regularly check the velvet strips on the arm. Make sure they are clean, no dirt or debris is present.
Prior to maintenance, always disconnect the record cleaning machine from the power outlet!
Technical specifications Vinyl Cleaner VC-S2 ALU
Nominal speed
30 r.p.m.
Power consumption
230V/800W, 120V/650W
Dimensions (W x D x H)
415 x 325 x 272 mm (fully assembled)
Weight
8kg (netto)
Fuse
T6,3A
Potential incorrect use and fault conditions
Pro-Ject products are manufactured to the highest standards and undergo strict quality controls
before leaving the factory. Faults that may possibly occur are not necessarily due to material or
production faults but can sometimes be caused by incorrect use. Some of these faults are as follows:
The platter doesn't turn although the unit is switched on:
•
The power cord is not connected to the unit.
•
The power cord is not plugged in to the AC wall outlet.
•
Broken fuse in the main switch.
•
Overheating protection is active.
•
Top clamp plate is not tightened properly.
How to adjust the height of VC-S2 ALUs record clamp
The VC-S2 ALU is pre-adjusted to spec for standard 80
–
180 g records. There is enough headroom,
so that the arm is optimally pressed against the record and the cleaning fluid can be completely
removed. The vacuum arm works best when it is parallel to the record when operating and the adhesive
strips is pressed gently on the surface of record. If the vacuum suction arm is not in the correct distance
from the record it may not be able to completely vacuum the cleaning fluid. In this case it may be
necessary to adjust the height of the clamp. You will need a Phillips screwdriver (to unscrew the set
screw of the clamp base part) and a 2.5mm hexagon key (to loosen motor spindle):
1.
Disassemble the clamp (2) by unscrewing the set screw (3) from the motor flange spindle (11)
