© Audio Trade GmbH · Pro-Ject 6 Perspe
X
· Revision 1.11.08/1.1.09
6
Connection to the amplifier
The record player has gold plated female RCA phono sockets (14) so you can substitute the interconnect
cables supplied with those of your choice for connection to the amplifier if you wish. Your dealer can advise
you on alternative cables. Use the Phono input (sometimes labelled gram, disc or RIAA) on your amplifier.
Make sure that the phono input offers correct matching and amplification for the type of cartridge used. Line
inputs (such as CD, Tuner, Tape or Video) are not suitable.
Take care to connect the left and right channels correctly. The right channel is usually marked red, the left
channel black or white. Check the manual supplied with your amplifier for relevant information. An earthing
wire may be connected to the screw terminal between the sockets if you encounter hum problems when using
the record player.
If your amplifier does not have an input suitable for phono cartridges you will require a separate phono
amplifier stage for MM or MC cartridges such as the PRO-JECT PHONO BOX or the PRO-JECT TUBE BOX
which is then connected between the record player and a free line level input of the amplifier.
For detailed product information please refer to the Pro-Ject web site
www.project-audio.com
.
Mains power connection, switching on and off
The turntable is supplied with a power supply suitable for your country's mains supply. Check the label before
connecting to ensure compliance with the mains rating in your house. Connect the low voltage plug from the
power supply to the record player's motor before connecting the power supply to the mains. Pressing the
power switch (20) alternately starts or stops the motor.
Fitting the lid
Fit the lid (dust cover 10) carefully over the hinge prongs and adjust the screws (12) until the lid stays open
where you want it to without being too stiff to open or close.
Maintenance and cleaning
Your record player requires little or no regular maintenance. Remove dust with a slightly moistened antistatic
cloth. Never use a dry cloth because this will create static electricity which attract more dust! Antistatic
cleaning fluids are available at specialist stores but must be applied sparingly to avoid damage to rubber
parts. It is recommended to fit the needle cover before cleaning or maintenance is carried out to avoid damage.
If the player is not used over a long period of time the drive belt can be removed to prevent unequal stretching.
!
Always disconnect the record player from the mains power supply as a precaution before maintenance!
Useful tips
The lid is not only a dust cover but also a resonant structure likely to be excited by, and to pass into the
plinth, the acoustic energy emanating from your loudspeakers during replay. It is therefore recommended
that the lid be removed for optimum sound quality.
The record player should be positioned on a low-resonance surface such as wood or multiple layer ply board
to avoid structural vibrations disturbing replay.
Technical specifications PRO-JECT 6 Perspe
X
Nominal speeds *
33,33/45,11 r.p.m.
Speed variance
±0,5%
Wow and flutter
±0,06%
Signal to noise
-73dB
Downforce range
15-30mN
Effective tonearm length
9 " (230mm)
Overhang 18mm
Power consumption
2W
Outboard power supply
16V/500mA AC, suitable for your country's mains supply
Dimensions (W x H x D)
460 x 160 x 365mm, dust cover open 460 x 420 x 465mm
Weight 10,5kg
Содержание Pro-Ject 6 PerspeX
Страница 1: ...INSTRUCTIONS FOR USE Pro Ject 6 PerspeX...
