© Audio Trade GmbH · Pro-Ject Pre Box S · Revision 2013.1.15
4
Replacing batteries
Proceed as follows:
Unlock and slide open the battery case cover
Replace the battery.
Make sure the battery is the right way round !
Close the battery case cover
Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.
Technical specifications Pro-Ject Pre Box S
Frequency response:
20Hz - 20kHz (±0,2dB)
Noise floor:
-100dB (A weighted)
THD: 0,001%
Gain: 8,5dB
Pre out:
1 pair RCA/phono sockets
Output voltage typically:
1V at 1kHz
Line-level inputs:
2 pairs RCA/phono sockets
Input impedance:
20kohms
Trigger Amp:
12V DC switching voltage
Trigger Amp:
2-pole 2,5mm co-axial jack
Trigger Switch:
digital switching signal
Trigger Switch:
2-pole 2,5mm co-axial jack
Outboard power supply:
18V/500mA DC, suitable for your country's mains supply
Power consumption:
100mA AC, <1W in standby
Replacement battery remote control:
1 x CR2032 / 3V or 1 x CR2025 / 3V
Dimensions W x H x D (D with sockets): 103 x 36 x 104 (109)mm
Weight:
630g without power supply
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright
©
2012. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
Содержание Pre Box S
Страница 1: ...INSTRUCTIONS FOR USE Pro Ject Pre Box S...
