© Pro-Ject Audio Systems · Pro-Ject Tuner Box S2 · Revision 2018.11.27
2
Dear music lover,
thank you for purchasing a Pro-Ject Audio Systems FM-tuner.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.
Warning of a hazard for the user, the unit or possible misuse
Important notice
Safety instructions
The power supply is used to disconnect the unit from the mains. Make sure that the power supply is easily
accessible at all times.
Never handle the device, the power supply while your hands are wet or damp.
Avoid letting liquids enter the device or the power supply. Never place any item containing liquid, such
as a flower vase on or near the device. Never spill any liquid on the device or the power supply. Never
place any naked flame sources, such as lighted candles on or near the device. The product shall not be used
in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.
Connectors
Make all connections whilst the tuner is disconnected from the power supply.
Take care to connect the left and right channels correctly. The right channel is usually marked red,
the left channel black or white.
Connection to an amplifier
Connect the output (Out) to any line livel input on the (pre)amplifier.
Antenna input
Connects to any antenna cable with a co-axial DIN-plug / US-model F-plug.
Mains power connection and methods to switch the unit on and off
Connect the low voltage plug from the power supply to the Power 5V socket of the tuner before connecting
the power supply to the mains. The unit can be switched on and off by using 2 different methods which are
equal in priorities.
1.
Using front pushbutton to switch on or into standby
The pushbutton on the front panel of the unit alternately turns the power on or returns it to standby mode. The
blue LED on the front panel shows that the unit is powered on.
If a trigger signal is present the unit can’t be
switched off by the pushbutton.
2.
Remote power on - triggers
The unit can be switched on via other Box Design components when a 12V trigger voltage is present at the
2.5mm socket marked Trigger Input. Special power-on cables (polarity
) in diverse lengths are
