6
3. After you have
activated the desired
massage zones, press
the Int or Ð
buttons to adjust the
intensity of the vibrat-
ing massage action.
Note: If no buttons on the hand control are pressed
for twenty minutes, the vibrating massage action
will stop.
To restart the massage action, follow steps
1 through 3 above.
HOW TO USE THE AUTOMATIC MODES (FULL
BODY WAVE, FULL BODY PULSE, AND UPPER
BODY WAVE)
1. Press the Mode
button repeatedly to
select the desired
mode. A mode indi-
cator will light to show
which mode is
selected. When Full
Body Wave is select-
ed, the upper body,
lower body, and thigh
zones will be activated
in sequence,
producing a wave-like massage motion. When Full
Body Pulse is selected, the upper body, lower
body, and thigh zones will be activated together
with a pulsing motion. The Upper Body Wave is
similar to the Full Body Wave, but only the upper
body and lower body zones will be activated.
2. After you have selected the desired mode, press
the Speed and Intensity buttons to adjust the speed
and intensity of the vibrating massage action (see
the drawing at the top of this page).
Note: If no buttons on the hand control are pressed
for twenty minutes, the vibrating massage action
will stop.
To restart the massage action, follow steps
1 and 2 above.
HOW TO ACTIVATE THE BUILT-IN HEATER
Whether the Manual mode
or one of the automatic
modes is selected, you can
add soothing heat to your
massage, if desired. To turn
on the heater, press the
Heater button. The Heater
indicator will light. Press the button again when you
want to turn off the heater. Note: When the heater is
on, the maximum intensity setting of the vibrating
massage action will be lower. Therefore, the intensity
may decrease slightly when the heater is turned on.
Note: If no buttons on the hand control are pressed
for twenty minutes, the heater will turn off.
To turn
on the heater, follow the instructions above.
HOW TO TURN OFF THE POWER
To turn off the power, slide the power switch to the
ÒoffÓ position. The power indicator will darken.
HAND CONTROL TROUBLE-SHOOTING
If the hand control does not function properly, make
sure that the transformer on the power cord is plugged
into a 120-volt outlet. In addition, make sure that the
hand control is properly connected to the massage
pad (see assembly step 2 on page 4).
PART LISTÑModel No. PFRX30070
R0597A
Key No.
Qty.
Description
1
4
5/16Ó x 2Ó Carriage Bolt
2
2
Arm Cap
3
2
5/16Ó x 3 3/4Ó Bolt
4
4
5/16Ó Washer
5
4
5/16Ó Nylon Locknut
6
4
Frame Cap
7
4
Pivot Cover
8
2
Armrest
9
2
Arm
10
1
Seat Frame
11
4
1/4Ó x 1 3/4Ó Screw
12
1
Massage Pad
Key No.
Qty.
Description
13
1
Headrest
14
1
Hand Control
15
1
Back Frame
16
1
Power Cord w/Transformer
17
1
Sling
18
4
1/4Ó Washer
19
2
5/16Ó Nylon Jam Nut
20
2
Plastic Bracket
21
1
Lower Frame
22
4
#8 x 3/4Ó Screw
#
1
UserÕs Manual (not illustrated)
