9
42
36
2
47
9. Cover the Upright Wire (42) with the Right Grip Plate
(36).
Be careful not to pinch the Upright Wire.
Tighten
two 1/2” Screws (48) and a 3/4” Screw (2) into the Right
Grip Plate and the Console Base (47).
48
9
10.Attach the Left Upper Body Arm (24) to the left Upright
(69) with two 3 1/2” Bolts (45), two Washers (38), and
two Star Washers (106) as shown.
Make sure that the
Left Upper Body Arm is on the indicated side of the
Console Base (47).
Attach the Right Upper Body Arm (not shown) to the right
Upright (not shown) in the same way.
11.
Make sure that all parts are properly tightened be-
fore you use the treadmill.
Note: Extra hardware may
be included. Keep the included allen wrenches in a se-
cure place; the large allen wrench is used to adjust the
walking belt (see page 26). To protect the floor or car-
pet, place a mat under the treadmill.
24
47
106
106
38
69
45
10
47
8. Set the Console Base (47) on the Handrails ( 71, 72).
Attach the Console Base with four 3/4” Screws (2).
Start
all four Screws before tightening them; do not over-
tighten the Screws.
See the lower drawing.
Make sure that the Upright
Wire (42) is routed below the two indicated round
posts (A).
Next, press the Upright Wire into the slot be-
tween the square post (B) and the Console Base (47).
2
2
72
71
8
A
B
47
42
