![background image](http://html1.mh-extra.com/html/pro-form/cardio-crosstrainer-800/cardio-crosstrainer-800_user-manual_1605513008.webp)
8
6
6. The Console (4) can be operated with four 1.5V
“D” batteries (not included); alkaline batteries
are recommended.
IMPORTANT: If the ellipti-
cal exerciser has been exposed to cold tem-
peratures, allow it to warm to room tempera-
ture before inserting batteries into the
Console. If you do not do this, the console
displays or other electronic components
may become damaged.
Remove the the bat-
tery cover and insert four batteries into the
Console. Orient the batteries as shown by the
markings inside the battery compartment. Then,
reattach the battery cover.
Note: The Console (4) can also be operated
with an optional power supply (not included)
instead of batteries.
To purchase a power
supply, call the telephone number on the
front cover of this manual.
Plug one end of
the power supply into the jack on the Console.
Plug the other end of the power supply into an
appropriate outlet that is properly installed in
accordance with all local codes and ordinances.
4
Batteries
Cover
5. Have another person hold the Upright (3) near
the Frame (1). Locate the wire tie (see the inset
drawing) in the Upright. Tie the lower end of the
wire tie to the Wire Harness (73) and to the
Right and Left Extension Wires (83, 86). Next,
pull the upper end of the wire tie upward out of
the top of the Upright. Then, untie and discard
the wire tie.
Tip: Use an elastic band or a
piece of tape to prevent the ends of the Wire
Harness and the Right and Left Extension
Wires from falling into the Upright.
Tip: Avoid pinching the wires during this
step.
Insert the Upright (3) into the Frame (1).
Then, attach the Upright with three M8 x 16mm
Patch Screws (53).
Tip: Start all the Patch
Screws before tightening them.
5
3
1
73
83
86
53
53
Wire Tie
73, 83, 86
Avoid pinching
the wires during
this step