7
69
82
113
73
83
71
71
72
72
4
85
83
4.
Open part bag A.
With the help of a second person,
hold the Console Base (85) near the Uprights (69, 82) as
shown.
Connect the Wire Harness (83) to the wire harness in
the Right Handrail Bracket (113).
Make sure to connect
the connectors properly (see the inset drawing). The
connectors should slide together easily and snap
into place.
If the connectors do not slide together easily
and snap into place, turn one connector and try to con-
nect them again.
IF THE CONNECTORS ARE NOT
CONNECTED PROPERLY, THE CONSOLE MAY BE
DAMAGED WHEN THE POWER IS TURNED ON.
Insert the wires harnesses into the Right Upright (82).
Hold the Handrail Brackets (73, 113) on top of the
Uprights (69, 82). Finger tighten two 1” Bolts (71) with
Internal Star Washers (72) into the Handrail Brackets
and the tops of the Uprights as shown.
Press the
Handrail Brackets towards the centre of the tread-
mill.
Then, tighten both Bolts.
3. With the help of a second person, carefully tip the
Uprights (69, 82) down so the treadmill pivots on the
Wheels (108) as shown.
Tighten a 3/4” Screw (6) into one side of the Base (109)
and one of the Wheel Housings (106). Attach a
long
Rear
Base Pad (105) and a
short
Front Base Pad (100) to the
Base with four additional 3/4” Screws (6) as shown.
Repeat this step on the opposite side of the treadmill.
With the help of a second person, carefully raise the
Uprights (69, 82) to the vertical position.
2.
Open part bag C.
See drawing 2a. Attach a Wheel (108)
to each Wheel Housing (106) with a Wheel Bolt (107)
and a Wheel Nut (21) as shown.
Do not overtighten the
Wheel Bolts.
See drawing 2b. Insert a Wheel Housing (106) into the
Base (109). (Note: It may be helpful to use a rubber mallet
to fully insert the Wheel Housing.) Next, press a Base
Endcap (99) into the Base.
Repeat this step on the opposite side of the treadmill.
105
105
108
109
106
106
106
108
21
6
6
106
108
106
99
109
107
107
2a
2b
108
109
69
82
3
6
6
100
6
100
