11
13. Have a second person hold the console assem-
bly near the Right Upright (89).
Connect the Wire Harness (88) to the console
wire.
See the inset drawing. The connectors
should slide together easily and snap into
place.
If they do not, turn one connector and try
again.
IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON.
Remove the long tie from the Wire
Harness and the tie from the console wire. Then,
insert the connectors into the Right Upright (89).
Set the console assembly on the Right Upright
(89) and the Left Upright (not shown).
Make sure
that no wires are pinched.
89
Console Assembly
Console Wire
Long
Tie
88
13
88
Console
Wire
14. Tighten six M8 x 25mm Bolts (5) with six M8
Star Washers (10) into the Uprights (85, 89) and
the Handrails (99, 101).
Start all six Bolts be-
fore tightening any of them.
See steps 5 and 8.
Tighten the four M10 x
95mm Bolts (8).
Press the Left Accessory Tray (104) and Right
Accessory Tray (106) into the console assem-
bly.
5
5
5
104
106
85
99
101
89
10
14
10
10 5
Console
Assembly
Tie
10
