Pro-face Xycom 3015, Руководство по оборудованию

Страница: 9 / 44

RISQUE
D’ EXPLOSION
Dans les situations hasardees, couper la courant avant
de remplacer ou de cabler les modules.
Warning:
You must disconnect the power cable and any other external cables con-
nected to the unit before opening the unit.To close the unit perform the open unit steps
in reverse order.
To Remove the Front Panel from the Rear Assembly
1.
Lay the unit facedown, and remove the four screws holding front panel to the rear
assembly (see figure 3).
2.
Flip the unit over and begin to lift off the front panel. If a touchscreen is installed,
disconnect the touchscreen cable at the top of the unit before completely remov-
ing the front panel.
To Access the Touchscreen Controller Card
1.
Lay the unit facedown, and remove the two screws holding the controller box to
the rear assembly (see figure 3).
2.
Locate the touchscreen controller inside the controller box.
3.
When replacing the card, unlatch and carefully ease the touchscreen controller out
of its connector slot.
Note:
Examine and record the jumper configuration that is unique to your old control-
ler. The new controller jumper settings must be set to be identical to the old controller
before installation.
CREATING A CUSTOMIZED LOGO
You may place a customized label on the unit. Figure 4 provides the dimensions and
recommended requirements for a customized label.
Once you have created a customized label, place it over the “Xycom Automation”
label.
Warning:
Safety regulations for hazardous locations will not allow inclusion of a stan-
dard power cord with these monitors. For installation outside of classified hazardous lo-
cations, a standard power cord with an IEC 320 termination can be used.
Product Overview 5
2.17(55.12)
0.67(17.02)
0.12(3.05)R
™
Figure 4. Customized Logo.