28
E
ngl
is
h
Connecting to the USB Interface
Attaching USB Clamp Type A (1 port)
When using a USB device, attach a USB cable clamp to the USB interface to
prevent the USB cable from being disconnected.
NOTE :
Watch your fingers. The edge of the clip is sharp.
Step
Action
1
Mount the clip to the USB mark
connector shell so that it
overlaps. The clip matches the 27 to 43.5 mm (1.06 to 1.71 in)
length of the USB connector.
NOTE :
When installing clamps to reduce cable stress onto both USB1 and
USB2, at USB1 overlay the clip on the side with the USB mark, and on USB2
the side without the USB mark. Make sure the ties do not interfere with the
other.
2
Align the clip and the USB cable connector shell. Adjust the
position of the holes where the clip is attached. To ensure stability,
select the clip-hole position that is closest to the base of the
connector shell.
