INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in China. PR2 9PP
Man Rev 1.1
CLEANING AND MAINTENANCE
SPECIFICATIONS
•
Always remove the plug from the mains socket and allow the radiator to cool down
before cleaning the heater.
•
Wipe the radiator with a soft damp (not wet) cloth.
•
Do not use any cleaning chemicals such as detergents and abrasives.
•
The timer has a small red switch, the function is as follows: I=Heater is under
manual control or =Timer function is ON.
•
Set the timer to position. There are 96 small plastic pins
around the timer, each correspond to 15 minutes interval.
•
When the pins are set outward the heater will be ON and
when set inwards the heater will be turned OFF.
CAUTION
: Do not use the timer function unattended.
•
The heater will not operate if timer if set to the position but
the pins have not been set accordingly or the thermostat is set too low.
•
If the heater looses its electricity supply, e.g. Switched off at the mains socket or in
the even of a power failure, the time should be reset after the power on again.
•
Rotate the thermostat knob clockwise to MAX position and switch the heater on.
•
Switch I is for low heat, switch II for medium heat and turn both switches on for
high heat. When the heating element is on the power switch will illuminate.
•
When your room reaches the desired temperature, slowly rotate the thermostat
control counter clockwise until the power light goes out. The thermostat can now
be left at this setting. As soon as the room temperature has dropped below the set
temperature, the unit will switch it self on automatically until the set temperature
has been reached again. In this way the room temperature remains constant with
the most economical use of electricity.
•
If you want to change the room temperature setting, rotate the thermostat knob
clockwise to raise the temperature, or counter clockwise to lower it.
USING THE TIMER
As is typical for all portable heaters -
This product is only suitable for well insulated spaces or occasional use.
Model
PEL00922
Heat Output
Rated Voltage
220-240VAC
Nominal heat output P
nom
0.9360kW
Frequency
50/60Hz
Min heat output P
min
0.0002kW
Rated Power
2500W
Max heat output P
max
0.9360kW
Auxiliary electricity consumption
At nominal heat output el
max
0kW
At minimum heat output el
min
0kW
In standby mode el
sb
N/A
With mechanical thermostat room temperature control plus day timer
YES/YES
