5
INSTALLATION INSTRUCTIONS
Do not make any electrical connections to the main engine battery or additional
batteries until the installation process has been completed.
The ProXtra may be mounted at any angle. For best results, place the ProXtra at
the desired location and mark the screw locations, using the mounting bracket as
a template.
Check for fit and appropriate thickness of the mounting area before drilling starter
holes. Use the four screws that have been provided to install the unit on a flat
surface as high above the water level as possible.
Locate the cable labeled
starting battery
and securely connect the ring terminal
of the black cable to the negative post of the starting battery. Locate the cabled
labeled
trolling
motor battery
and securely connect them to the trolling motor
battery or batteries as shown. (Red wire to + terminal/Black wire to – terminal.)
Locate the purple wire at the end of the starting battery cable assembly. Using
the supplied quick connector, attach the purple wire to any 12 volt source on the
boat that is disabled when the boat is not in use. The purpose for this connection
is to disable the ProXtra circuitry during times that the battery may be charged by
other means (i.e., AC powered battery charger).
