SPEEDY F1 usage instructions
22
Figure 46: Loosen the nut of the caster wheel axle
using the wrench
Figure 47: Caster wheel axle nut completely re-
moved
When
mounting the caster wheel fork
, insert
the caster wheel axle back into the caster
wheel bearing block, use the supplied wrench
to tighten up the nut of the caster wheel axle
again (hold the caster wheel axle firmly) and
secure it with thread lock.
The nut of the caster wheel axle may not be
tightened by more than 3 Nm to ensure it runs
smoothly. In case more sluggishness is de-
sired, this can be achieved using a higher
tightening torque.
21 Footrests
Make sure the ground clearance under
the footrest is sufficient. Experience shows that
this should not be less than 1 cm. This must be
observed for the angle adjustment of the foot-
plate support and when setting the lower leg
length.
21.1 Angle adjustment of the footplate
support
The following instructions are intended
for and may only be carried out by a rehabilita-
tion specialist dealer or PRO ACTIV
The
angle
of the
footplate support
can be set
by releasing the M6 fastening clamp screws
(AF 5 mm) on the lower side of the footrest
support plate. When the angle adjustment is
completed, tighten the M6 fastening clamp
screws (AF 5 mm) again to maximum 5 Nm.
This tightening torque should not be exceeded
as higher tightening torques can damage the
clamp.
Figure 48: Foot support with footrest angled from
below
Footplate support
Footrest
support plate
M6 fastening
clamp screws
Wrench
Caster wheel
bearing block
Nut on the
caster wheel
axle
