Prizmatix
9 |
P a g e
UHP-F LED Illuminator User Manual
3.3.2 Typical System Setup
Typical UHP-F illuminator setup for microscope will include following components:
(1)
UHP-F illuminator - Light Guide coupled LED light source
(2)
Liquid Light Guide - Light guide to deliver the light to microscope
(3)
Microscope adaptor - Enable connection of the light guide to the light port of the
microscope (the specific type of this part is dependent upon the microscope type
and it is sold separately)
3.4 Initial Set-up of UHP-F illuminator
1.
Set Power Switch on back panel of the unit to OFF position and connect power
adaptor to the back of the unit and into wall mains socket.
CAUTION
!:
The power adaptor cable connector and control cable connector have a
key for correct connection. Please pay attention to the correct orientation of the
connectors.
2.
Set both the TTL and Ain (Analog Input) switches on back panel to
‘
Int
’
position.
3.
Connect the Light Guide to the front panel connector and secure it by the two set-
screws.
