Priva FS Concentrator, Руководство по установке

Страница: 15 / 28

FS Concentrator – installation manual – 1.2 15
4. The installer connects a power cord. This is done by splitting the cord and connecting
two wires to the provided cable entry plug. The location on the PCB on which the plug
should be connected is shown in the blue square in Figure 1.
L = Line wire;
N = Neutral wire.
5. Make sure that the jumper indicated in the green square in Figure 1 is in the “KEEP”
position (refer to page 18).
6. Mount the FS Concentrator to the selected location, for instance by using the supplied
clips and screws.
a. Fasten the clips to the casing by screwing the screws through the holes in the
corners of the casing into the clips.
b. Then fasten the FS Concentrator by means of these clips to the intended
location, for instance with screws or bolts and nuts (not provided in the FS
Concentrator package).
c. Please obey any applicable local regulations.
7. Fasten the provided Ethernet connector plug to the also provided Ethernet cable
according to its instructions.
8. Connect the Ethernet cable to the external Ethernet connector of the FS Concentrator
and to the network.
9. Set the switch indicated in the yellow square in Figure 1 to the “ON” position.
10. Close the casing and connect the electrical power.
11. The installer makes sure that the led on the FS Concentrator is functioning, indicating the
power and Ethernet connection have both been properly connected.