Setup Instructions
Anamorphic Lens
HD-6000M
Setup Instructions
Anamorphic Lens
HD-6000M
STEP 4
Flip the
lens unit
back upright. Remove the cover
of spring box by releasing the four cap screws
using the
L-wrench 3 mm (Fig 4-a).
After this, using the
L-wrench, 4 mm,
remove the
both
shipping rails,
shown with arrows in a Fig 4,
by releasing the each
cap screw, M6 x 10,
locating under the spring cover
(Fig 4-b).
Fig 4
a)
a)
a)
a)
b)
b)
STEP 5
Now, refer to
Fig 5,
attach the four
stand rails
to
stand plate
with
cap screw
s
, M6 x 10
. Make sure
the 12 mm Ø rails and 15 mm Ø rails are placed to
the correct spots on a
stand plate
. Tighten screws
in the
slots
of
stand plate
securely using the
L -
wrench, 4 mm.
in this step also insert the four
slide lock
s to their
places on a
stand rail
s 15 mm Ø. Make sure the
each lock pair is in a same plane on a rail. The final
positions to the locks will be defined by your setup,
and thus they may need to be repositioned later,
when setting up the system.
NOTE:
Some setups may need an extra height to the
slide travel. In order to extend the travel, use the
rail
extender
s of main rails
(Fig 5)
. The set of extension
rails increases the slide travel for 4.5 cm. The each
extension rail is screwed securely into the main rail,
after which it is working as a single, longer
stand rail
.
Fig 5
STEP 6
Now very carefully set the
lens unit
onto the
stand plate
with
stand rails
exactly as presented
in
Fig 6,
so that 12 mm Ø rails go through the
linear bearings of lens drums on sides.
Referring to
Fig 6,
turn the upper
slide lock
s aside from the
lens when inserting the lens, and let the lens slide
down onto the lower pair of
slide lock
s. Connect
the
lens unit
to four rails
with
cap screw
s
, M6 x 10
(Fig 6-a).
Tighten the screws securely using the
L -
wrench, 4 mm.
Finally attach the spring cover back with four cap
screws using the
L-wrench, 3 mm (Fig 6-b).
Your lens is now ready for setting up !
Fig 7
STEP 7
Make sure the projector is turned on. It is
helpful to have a picture that fills the entire
panel of 16:9 projector. With a 2.40:1 source
material the vertical expand is good to be
performed to the picture at this step
(Fig 7).
Now carefully adjust the focus of projector.
Also make sure the image is symmetrically in
the center of the 2.40:1 screen.
Setting up the system:
Fig 6
a)
a)
a)
a)
b)
b)
b)
b)
