Step 1: Assemble the main wing (Fig-1)
Unfold the main sail. Flex and insert the free end of each thin wingtip batten
into the wingtip corner pocket to flatten each wingtip. Battens go on the
back side of the sail (the side without the printed logo).
Rotate the aluminum “T” fitting on the spine till it is perpendicular to the
spine. Insert the collared end of each spreader rod into the “T.”
Tension the main wing by slowly and carefully flexing each spreader until
you can fit the wingtip cap onto the spreader end.
Twist the spreaders in the center T so that the small holes in the plastic
collars against the center T are aligned. The holes have been matched to
the individual flex of each rod at the factory so this step ensures that your
frame will flex symmetrically.
Step 2: Lay out the forward wings and bridle (Fig-2)
Step 3: Connect the forward wings and main wing (Fig-3)
Slide the forward spine section into the aluminum ferrule on the main wing
spine. Hook the small metal clips on the side tension lines into the holes in the
wingtip caps.
Step 4: Connect the main bridle (Fig-4)
Hook the larger silver clip on the main bridle into the eye on the forward
side of the center T fitting.
Check that the main bridle, nose lines, and side tension lines aren’t tangled
around parts of the kite.
TAIL
TAIL
NOSE
NOSE:
Spine
Canard
Nose tension lines
Side tension lines
Tow Point
Canard
Canard Tension adjustor
Spine
Nose line
Side Line
Center-T
Spine ferrule
Spine ferrule
Spreader
ZERO-G ANATOMY
This end forward
wingtip battens
wingtip caps
Nose tension
adjustor
Main bridle
Nose tension adjustor
Main Sail
FRONT VIEW
Spreader
Center-T
Main Sail
Main Sail
TAIL
TAIL
NOSE
NOSE:
Spine
Canard
Nose tension lines
Side tension lines
Tow Point
Canard
Canard Tension adjustor
Spine
Nose line
Side Line
Center-T
Spine ferrule
Spine ferrule
Spreader
ZERO-G ANATOMY
This end forward
wingtip battens
wingtip caps
Nose tension
adjustor
Main bridle
Nose tension adjustor
Main Sail
FRONT VIEW
Spreader
Center-T
Main Sail
Main Sail
PUTTING IT TOGETHER
PUTTING IT TOGETHER
PUTTING IT TOGETHER
Fig-1. Assemble the main wing
and insert wingtip battens
Fig-2. Lay out the forward spine
section and sails as shown
Fig-3. Connect the main wing to the
forward wings and clip in side lines
Fig-4. Clip main bridle into center
T and check for tangles
NOTE:
Your Zero-G is comes from the factory in two separate parts to make
it easy to assemble without tangling up the bridle lines. But once you’re
familiar with it you may prefer to leave the three bridles clipped in place when
you fold it up for storage.
Some day you will likely lose one of your tiny wingtip battens in the grass. We
include two extras with every kite, just in case…
Video:
To see a video showing how to assemble your Zero-G, visit the Prism
website at www.prismkites.com and click on “Support”
ZERO-G ANATOMY
PUTTING IT TOGETHER
WWW.PRISMKITES.COM
Front View
Side View