RevEAL Studio3 User Manual – April 2013 - Prism Projection, Inc.
Step 2: After attaching the appropriate connector to the power cord you can attach the power cord to the fixture.
The power cord will go into the power-in port. Slide the connector into the port and twist the connector
clockwise.
Step 3: Now that the unit has power you need to provide data to the unit. This is done by plugging in an
approved 5 pin DMX cable. The data-in port is found on the rear of the fixture. If you have daisy chained your
units, data-in from your second unit should come from the data-out port of the first unit. Continue attaching
cables in this fashion, 1 to 2, 2 to 3, and so on. Follow best practices for DMX wiring. Do not exceed
recommended cable lengths or number of receivers on a chain.
Care and Maintenance
It is recommended that care always be exercised when handling the fixture. It contains electronic components
and is susceptible to damage if dropped or exposed to excessive heat (above 105° F/40° C) or water. The fixture
is not recommended for outdoor locations unless in an approved outdoor protective enclosure. Periodically
check and clean the air filter at the base of the fixture. To clean the front lens on the fixture body, wipe down
with a clean soft cloth. Periodically check the fixture yoke hex bolts to make sure they are securely fastened.
The air vents located around the top portion of the fixture body should be clear of obstructions.
.
Product Overview
Beam
Angles
Adjustment
10
‐
90
Degrees
9
5/8”
Accessory
Slot
Barn
Doors
Yoke
Slide
Adjustment
Screw
(2)
Set
Knob
Yoke
Position
Knob