Adjusting Yoke Height
To facilitate some mounting orientations, it may be necessary to
extend the yoke. DO NOT ATTEMPT WHILE THE INSTRUMENT IS
HANGING.
1. Loosen the lock nuts on either side of the yoke.
2. Slide the yoke to desired extension.
3. Be sure to tighten lock nuts on both sides of the yoke.
Attaching Data and Power Cables
Note:
This lighting fixture can be used individually or modules can be daisy chained. In a chain
of fixtures each module can be individually addressed, or each can have its own address
wherein each fixture is independent of the others.
Step 1:
If Needed attach an appropriate connector to the end of the power cord
included with the product. Any connector you attach to the end of the product must be
rated for 15 Amperes and 250VAC, and of the grounding type. The conductors in the
power cable are color coded for ease of assembly.
Wire Color
!
Conductor function
Green or Green with Yellow Stripe
"
GROUND
Blue or White
"
NEUTRAL
Brown or Black
"
LINE
Step 2:
After attaching the appropriate connector to the power cord you can attach the
power cord to the fixture. The power cord will go into the power-in port (blue). Slide the
connector into the port and twist the connector clockwise.
Step 3:
Now that the unit has power you need to provide data to the unit. This is done
by plugging in an approved 5 pin DMX cable. The data-in port is found on the rear, of
the fixture. If you have daisy chained your units, data-in from your second unit should
Prism Projection Inc. - RevEAL Studio Operating Manual
8