Printronix Auto ID T8204, Руководство пользователя, Страница: 44 / 77

44
The printer will stop after the specified
ODV-2D > Control > Num Retry
attempts. After you clear the error
message, the printer will print the same label or the next label, depending on the setting for
ODV-2D >
Control > Max Retry Action
.
Grade&Report
In this mode, the entire print job will print uninterrupted. If one or more errors is detected, the printer status
indicator lamp flashes, the alarm sounds, and the error mes sage “Bar code fails / Job has errors” displays.
IMPORTANT The error message lets you know that at least one bad form printed. To determine
which form(s) are bad, you must manually scan all of them.
The printer remains in a fault condition until you press the PAUSE key. This clears the error message and
takes the printer OFFLINE. Correct any condition that may have caused the fault, then press PAUSE to
place the printer back ONLINE.
Rescan Form
This mode is like the Retry Form mode, however, instead of backing up and overstriking the form, the
printer will back up and rescan the bad form and any other forms that have already printed (see “Forms
Printed After an Error Detection” ).
NOTE: The printer will only attempt this once before declaring an error.
If the printer scans these forms correctly on any of the rescans, it will continue printing with the next form.
If the printer fails to scan these forms correctly, it will overstrike the forms, stop, and indicate an error like
Stop mode. After you clear the error message, the printer will skip several blank labels, depending on the
setting for
ODV-2D > Control > Skip Labels
.
It will then slew to the next top of a blank form and reprint the same form or go the next form, depending on
the setting for
ODV-2D > Control > Max Retry Action
.
NOTE: The only difference between Rescan Form and Rescan&Stop is that when a form still fails after all
the rescans, Rescan Form will overstrike the bad form, whereas Rescan&Stop will not.
Rescan&Retry
This mode is similar to Rescan Form with one exception: after the printer has rescanned the form and
overstruck it if there was still a fault, it will reprint and rescan the same form again.
NOTE:
The printer will only attempt this once before declaring an error.
The number of times the printer will attempt to
reprint
the bad form is determined by the
ODV-2D >
Control > Num Retry
setting.
If the printer scans these forms correctly on any of the rescans or reprints, it will continue printing with the
next form.
If the printer fails to scan these forms correctly on all the rescans and reprints, it will overstrike the forms,
stop, and indicate an error like Stop mode. After you clear the error message, the printer will skip several
blank labels, depending on the setting for
ODV-2D > Control > Skip Labels
.
It will then slew to the next top of a blank form and reprint the same form or go the next form, depending on
the setting for
ODV-2D > Control > Max Retry Action
.
Rescan&Stop
This mode is like the Retry Form mode, however, instead of backing up and overstriking the form, the
printer will back up and rescan the bad form and any other forms that have already printed (see “Forms
Printed After an Error Detection” ).
NOTE: The printer will only attempt this once before declaring an error.
If the printer scans these forms correctly on any of the rescans, it will continue printing with the next form.