Prinetti IA1864A, Инструкция по эксплуатации

Страница: 9 / 16

09
AFTER SALES SUPPORT AU 1300 777 137 NZ 0800 824 556 service@unclebills.com.au
1. Connect the plug into a power outlet and switch on. Press the main power switch on
the back of the Tower Heater to the “I” (ON) position. The Tower Heater will beep, and
the LED touch screen control panel will illuminate to display the room temperature.
2. Press the button on the LED touch screen control panel (or remote control) to
power ON, the Tower Heater will enter fan only mode. The fan will activate but the
Tower Heater will not emit any heat.
3. Once the Tower Heater has been switched on by the main power switch, and the
button on the LED touch screen control panel (or remote control) has been
pressed, use the MODE button to select a heating mode.
Low Heat Mode
Heats at 1000W for low level heating. On this mode the
Tower Heater will reach the desired temperature slower
as it blows at low heat.
High Heat Mode
Heats at 2000W for high level heating. On this mode the
Tower Heater will reach the desired temperature faster as
it blows at high heat.
4. Press the SWING button on the LED touch screen control panel (or remote control)
to activate the oscillation. With this function the Tower Heater will oscillate side
to side which helps circulate the heat in the room. This function will work in any
mode. Ensure you switch off the oscillation function once you are finished to
return the Tower Heater back to the starting position.
5. Press the timer button on the LED touch screen control panel (or remote control)
to select a time. The timer is setup in 30 minute increments and can be set from
0.5 hours (30 minutes) up to 7.5 hours (7 hours and 30 minutes).
6. Press the temperature control button on the LED touch screen control panel
(or press the temperature increase/decrease buttons on the remote control)
to adjust the temperature setting of the Tower Heater. The temperature settings
range from 18-45˚C.
7. When you are finished using the Tower Heater, press the button on the LED
touch screen control panel (or remote control). The heat will turn off but the fan
will continue to operate until the Tower Heater has cooled down. The LED touch
screen control panel will display the temperature of the Tower Heater until it
returns to room temperature.
8. Once the fan has stopped operating, switch off the main power switch at the
back of the Tower Heater, and unplug the unit from the power outlet.
CAUTION:
Never block the openings of the Tower Heater or cover the Tower Heater
whilst in use. Covering the Tower Heater may create a risk of fire.
Instructions