Princess 332832, Инструкция по эксплуатации, Страница: 8 / 20

8
Note:
• Do not allow steamer to run dry.
• Do not unscrew the plastic nut during using.
• Do not aim the steam nozzle at anyone, the steam is very hot.
• Be careful when handling garments on the clothes hanger hook. Pulling on the garment with too much
force may cause the unit to overturn.
• Do not touch silk or velvet with steam nozzle
• Only use easy-roll casters for mobility during operation, but not the handle of unit.
RESET TIMER
There is an inner timer to preserve the total operating time of the appliance. After every 30 hours of use,
the ‘TIME TO CLEAN’ indicator light illuminates with 5 beep sounds each time you turn on the unit.
Now you have to reset the timer. Press the buttons
and at the same time for 3 seconds. There is a
long beep and the timer reset is finished.
CLEANING AND STORAGE:
We recommend you follow this procedure at least once a week.
1. After using the steamer, switch the unit off (the power indicator light will go out)
2. Unplug the unit from the outlet.
3. Allow the steamer to cool for at least 30 minutes.
4. Remove the hose and shorten the hanger rod, then set them aside.
5. Remove and drain the water tank. Rinse the water tank with fresh water, and drain completely.
Place the water tank back on the water reservoir.
6. Drain the vertical steamer by removing the drain cap and emptying the contents.
7. Flush the water reservoir and the hose with fresh water, and drain completely. Replace the drain cap.
8. Wrap the hose around the hanger rod and place the steam nozzle on the rotatable hanger.
9. Clean the hand protection plate, hard sofa brush, lint brush, fabric brush, pant press and rotatable
hanger in soapy water. Dry well. Store in accessory box. See fig 11.
10. Wipe the outside of unit with a wet cloth.
11. Rewind the plug by pressing the cord rewinder foot-step.
12. Store in a cool, dry place.
Note: Do not immerse the base in water or other liquids.
REMOVING MINERAL BUILD-UP:
One common problem with steamer is mineral build-up caused by high mineral levels in
many municipal water supplies. Mineral residue inside the internal pipes and heater can
cause intermittent steaming or, in some cases, no steaming at all. According to the water
quality in different regions, we advise you to remove the mineral build-up after using for
7-15 days. Please take note of the following procedure.
fig. 9 fig. 10
fig. 11