WARNING:
The EPB system must be activated after finishing service work on the brakes.
Make sure the vehicle is properly blocked before activation of the system.
1. To close the brake pads after finishing the maintenance/service work on the brakes, use
UP/DOWN
button to select Activate Brake from Select Function menu and press ENTER
button.
1) Read Codes
2) Erase Codes
3) Deactivate Brake
>4) Activate Brake
2. Wait while the tool is activating the brakes, you may hear the calipers opening. When they
are activated successfully,
Activation done, Go to Adaptation (Yes) or (No)
message comes
up.
Note: It is necessary to do the adaptation only when brake pads have been changed. If you did
not change them, use UP/DOWN button to select NO to exit. If the
Activation failed
message
does not go away, then contact your local distributor or the manufacturer’s customer service
department for assistance. If a
Selected function is not supported
message shows on the
display,
Check that the park brake is released;
Repeat the process.
3. If you do wish to set the thickness of the new pads in the caliper, press
ENTER
button to
continue.
If you do not wish to do the adaptation of caliper at this moment, press
EXIT
button or use
UP/DOWN
button to select NO and then press
ENTER
to exit.
Mercedes SBC
The W3000 is able to deactivate/activate the SBC functions. This is necessary to do the
following: Change brake fluid/bleed brake system, inspect brake air, read/clear SBC trouble
codes, and retrieve ECU information on Mercedes vehicles that are equipped with SBC
system.
Diagnose SBC On Mercedes
Reading Codes
1). Use
UP/DOWN
button to select SBC-Mercedes from Diagnostic
Menu and press
ENTER
button to confirm.
1) VOLKSWAGEN
2) AUDI
>3) MERCEDES
4) VOLVO
2. Use
UP/DOWN
button to select Read Codes from Select Function menu and press
ENTER
button to confirm.
>1) Read Codes
2) Erase Codes
3) Deactivate Brake
4) Activate Brake
