ENTER
1A=REMOVE
2 : 0 0
5. The scan feature is used to check the time values on
other active channels. There are two different ways
to scan active channels. Press the
SCAN/UP
or
SCAN/DOWN
button.Or press any of the active
TIMER
CHANNEL
buttons. If no other button is
pressed within 5 seconds, the display will change to
show the timer with the least amount of time left.
6.You can change the sound level of the alarm in
RUN
MODE
. Press and hold the
PRINCE CASTLE
LOGO
; then, within six seconds, press either the
SCAN UP
BUTTON
or the
SCAN DOWN
BUTTON
.
The
SCAN UP
BUTTON
adjusts the sound level to
the louder alarm, and the
SCAN DOWN
BUTTON
adjusts the sound level to the lower alarm.
VII CLEANING
1. Do not allow grease to build up on the timer, wipe it
down daily with clean damp cloth.
IMPORTANT:
Do not use abrasive or chemical cleaners
on your timer, this may cause damage to the overlay.
VIII PART LIST
ITEM
PART NUMBER
DESCRIPTION
1
69-079S
Rivet Plastic Push Pin
2
840-100
Rear Cover
3
840-134S
Main P.C.Board
840-109S
Auxillary P.C.Board
(840-C8D & 840-C16D)
4
71-042-02S
Display Board
5 88-653-2-7S
Speaker Assy.
6
840-096S
Switch Panel Assy.
(840-C8 Series)
840-110S
Switch Panel Assy.
(840-C4 Series)
7
70-048S
Knob W/Washer (Pkg of 2)
8
840-103
Chassis (840-C4 & C8)
840-115
Chassis
(840-C8D & C16D)
9
72-292S
Power Supply (110V)
72-293-01JS
Power Supply (100V)
72-293-04FS
Power Supply (220-240V)
*
10
840-140
Left Probe Connector
840-141
Right Probe Connector
*
Not Shown
VI OPERATION
1. Press a channel button to activate a timing cycle.
(All channels can be activated and running at the
same time.) The channel with the least amount of
function time remaining will be displayed in the
FUNCTION DISPLAY
along with its next function.
The time remaining will countdown in the
TIME
DISPLAY
, and the time value
M:S
or
H:M
will be
illuminated.
2. Press the desired channel button three times within
five seconds to cancel an active timing cycle.
IMPORTANT:
The channel timer buttons multi-
colored LED indicator shows the status of the
timer. The indicator has three colors: green,
yellow, and red. The LED will be green during
the first 70% of the countdown. It changes to
yellow during the next 20% of the countdown. It
will be red during the final 10% of the countdown,
and will start flashing red once the time has run
out.
Note:
If a Manual Cancel is programmed into a
duty function the LED will flash red until the
channel button has been pressed . If an Auto-
matic Cancel is programmed the LED will flash
green for 5 seconds and the alarm will automati-
cally turn off.
3. The timer will countdown from the programmed
value to zero. When the complete cooked time is
finished, the TIME DISPLAY flashes
0 0
and the
alarm sounds.
4. When the timing cycle is complete, and the alarm
sounds, press the channel button with the flashing
red indicator to cancel the alarm.
8
Printed in USA 3/06 © 2006
840-50
9
rev
A