Printed in USA 12/06 © 2006
4
755-503revB
Timers
755 Series
Programming for Multi-Display Timers
Timer Programming
1
Two different timing cycles can be set up for each channel. These are called “Menu 1” and “Menu 2”. To change from one menu to the other, all channels
must be idle. Simultaneously press both the UP and DOWN arrow buttons for 6 seconds. The displays will change between the single-line display (Menu
1) and the three-line display (Menu 2).
(Menu 1)
(Menu 2)
2
Countdown Mode
NOTE: This mode can only be entered when all channels are idle.
Enter the Countdown Mode by holding the UP arrow button for 6
seconds. This will determine if all the timing cycles count up from 0:00
or count down to 0:00. Use the UP or DOWN arrow buttons to toggle
between count up or count down. Display 1 will indicate “C-uP” or
“C-dn”. When the desired mode is obtained, momentarily press any
channel button to save it and return to Timing Mode.
NOTE: To return to Timing Mode without saving, momentarily press the
PRINCE CASTLE LOGO button.
3
Volume Level Selection
NOTE: This mode can only be entered when all channels are idle.
Press and hold the DOWN arrow button for 6 seconds to initiate the
Volume Level Setup Mode. In this mode the timer’s audio volume can be
set to one of three different levels by using the UP and DOWN arrow
buttons. A display will sequence through “SL-1, SL-2, SL-3”. When the
desired level is obtained, momentarily press any channel button to save
the setting and return to the Timing Mode.
NOTE: To return to Timing Mode without saving, momentarily press the
PRINCE CASTLE LOGO button.
4
Restoring Factory Presets
Simultaneously pressing both the UP arrow button, DOWN arrow button and the PRINCE CASTLE LOGO button during the first 6 seconds after
applying power to the timer will reset all channels back to their factory default settings.
